This is a strawberry treat holder svg I found at svgcuts.  It measures approximately 3″ long x 2.5″ wide.  The top comes off so you can fill it with Valentine’s Day goodies.

I cut it out with my Cricut Explore.  I can’t remember if the svg would open already to size, ready for cutting, with my Cricut Expression (because I could use the SCAL program with that), but you can still cut these SVG’s out with the Explore, you just have to size them yourself, which can be tricky.  I just sized the top of my strawberry a bit bigger than my bottom.

I stuck all the pieces on with double sided tape, which I noticed was starting to come apart after a few days.  A really good adhesive is suggested for this project, I just don’t know what kind of adhesive is a good one.  Once everything was stuck together I bedazzled it all with some red and yellow gems, and some green ribbon in the stem.  There are two holes in the stem which are a good size.  I could have actually put more ribbon in, which might have been cuter.

So here’s one unique idea to make treat giving a little more special on Valentine’s Day!